@article{oai:kyutech.repo.nii.ac.jp:00001094,
 author = {Maeda, Y and Takaya, K and Kuwabara, Nobuo and 桑原, 伸夫},
 issue = {3},
 journal = {IEICE Transactions on Communications},
 month = {Mar},
 note = {For a wireless communication system to work effectively without interference, the electromagnetic environment needs to be controlled. We experimentally and analytically investigated the requirements for controlling the electrical field strength and delay spread so as to achieve the best communication without electromagnetic interference in selected regions for a 2.4-GHz-band wireless LAN system. To control the coverage, partitions were placed around desks in a test environment and covered on the inside with electromagnetic absorbing board from the top of the desks to the top of the partitions; four indoor environments that combined one of two wall-material types and one of two partition heights were used. The transmission loss and delay spread were measured, then calculated using ray tracing to verify the effectiveness of using ray-tracing calculation. The throughput and BER characteristics were measured for the same environments to clarify the requirements for controlling the coverage. We found that covered and uncovered regions could be created by using partitions with absorbing boards and that the delay spread must be less than 15 ns and the received-signal must be stronger than -75 dBm for a region to be covered. We verified that the delay spread can be calculated to within 5 ns and the received-signal level can be calculated to within 5 dB of the measured data by using ray tracing. Therefore, ray tracing can be used to design antenna positions and indoor environments where electromagnetic environments are controlled for 2.4-GHz-band wireless LAN systems.},
 pages = {525--531},
 title = {Requirements for controlling coverage of 2.4-GHz-band wireless LANs by using partitions with absorbing board},
 volume = {E83-B},
 year = {2000},
 yomi = {クワバラ, ノブオ}
}