@article{oai:kyutech.repo.nii.ac.jp:00005826,
 author = {Noda, Nao-Aki and 野田, 尚昭 and Sano, Yoshikazu and 佐野, 義一 and Aridi,  Mohd Radzi and Tsuboi,  Kenji and Oda,  Nozomu},
 issue = {11},
 journal = {Metals},
 month = {Nov},
 note = {The work roll is one of the most important tools in the steel rolling industry. Work rolls are used under extremely severe conditions such as high temperature, high loading, and an aggressive atmosphere. To meet those demands, bimetallic rolls have recently been used to replace conventional single material rolls. Usually, a compressive residual stress is introduced to prevent surface cracking. However, a tensile residual stress at the center appears to balance the compressive residual stress. This center residual stress sometimes causes roll failure. In this paper, therefore, a simulation is performed using the finite element method (FEM) for the quenching process of the bimetallic roll by considering the creep behavior. Then the effect of pre-heating conditions is discussed. The results show that the maximum stress point for the tensile stress at the roll center for non-uniform heating is 24% less than that achieved with uniform heating, although the same compressive stresses appear at the surface. Then, using different work roll diameters, the center tensile residual stress for non-uniform heating is found to be smaller than the uniform heating. Also, it is found that the area ratios of the shell-core only have a small influence on the residual stress of the bimetallic roll for both heating treatments.},
 pages = {1--10},
 title = {Residual Stress Differences between Uniform and Non-Uniform Heating Treatment of Bimetallic Roll: Effect of Creep Behavior on Residual Stress},
 volume = {8},
 year = {2018},
 yomi = {ノダ, ナオアキ and サノ, ヨシカズ}
}