@article{oai:kyutech.repo.nii.ac.jp:00006947,
 author = {酒井, 悠正 and Sakai, Hiromasa and Noda, Nao-Aki and 野田, 尚昭 and Sano, Yoshikazu and 佐野, 義一 and 張, 国偉 and Zhang, Guowei and Takase, Yasushi and 高瀬, 康},
 issue = {12},
 journal = {鉄と鋼, Tetsu-to-Hagane},
 month = {Nov},
 note = {The bimetallic work rolls are widely used in the roughing stands of hot rolling stand mills. The rolls are classified into two types; one is a single-solid type, and the other is a shrink-fitted construction type consisting of a sleeve and a shaft. Regarding a shrink-fitted construction type, the interfacial creep sometimes appears between the shaft and the shrink-fitted sleeve. This interfacial creep can be regarded as the relative displacement between the sleeve and the shaft, which often causes the roll damage. In this paper, the FEM simulation is performed to clarify the effect of driving torque on the interfacial creep by considering the driving motor torque. It is found that the relative displacement in the interfacial creep is accelerated by the presence of the motor torque significantly. With increasing the shrink fitting ratio, the relative displacement in the interfacial creep decreases. The effects of motor drive torque on the stress, the displacement and average displacement along the interface were also discussed by varying the motor torque.},
 pages = {1126--1134},
 title = {スリーブ組立式圧延ロールの界面クリープに及ぼす駆動トルクの影響},
 volume = {105},
 year = {2019},
 yomi = {ノダ, ナオアキ and サノ, ヨシカズ and タカセ, ヤスシ}
}