@article{oai:kyutech.repo.nii.ac.jp:00000078,
 author = {寺井, 久宣 and Terai, Hisanobu and 郝, 明暉 and Hao, Minghui and Kikkawa, Koichi and 吉川, 浩一 and Mizugaki, Yoshio and 水垣, 善夫},
 issue = {654},
 journal = {日本機械学會論文集. C編},
 month = {Feb},
 note = {This paper presents a new analytical method to estimate the thickness of an undeformed chip in ball-nosed end milling. It has been firstly pointed out that the geometric situations on the determination of the thickness are categorized in three cases based on the relationship among the milling parameters. Secondly each corresponding case has been reduced into a comprehensive equation with introducing a coordinate system of tool axis orientation. Then the result of analysis has been displayed in 3D graphics. Through the analysis of the equations, it was found that the tool axis orientation had direct influence to the thickness of the undeformed chip. Besides the description of analytical solving procedures, some experiments of undeformed chip thickness have been shown and the brief conclusion has been mentioned too.},
 pages = {553--558},
 title = {多軸ボールエンドミル加工における切取り厚さの理論解析},
 volume = {67},
 year = {2001},
 yomi = {キッカワ, コウイチ and ミズガキ, ヨシオ}
}